American Standard NextGen Selectronic 7755105.002 Tested
A quick demo of the American Standard NextGen Selectronic touchless faucet: 0.5 gpm flow, 55-second safety timer, and top-mount install.
Reviewed by
Scott Ayres
Welcome to the Product Demo lab where I (Scott) demo products so you can make an educated buying decision. I keep it real, honest and laid back.
This post contains affiliate links. I may earn a commission at no extra cost to you.
Hand under the gooseneck, water flows, no handle, no delay, no guessing if the sensor saw you. The American Standard 7755105.002 NextGen Selectronic Integrated Faucet reads your hand at the spout, kicks on the water, and shuts off when you pull away. No handle, no knob, no lever. If you’ve been searching for the standard NextGen Selectronic and wondering what it looks like in motion, that’s the whole point of this demo.
Quick Verdict
Wave your hand, water runs, no control box hiding under the sink. The Standard NextGen Selectronic is a touchless faucet built around a single-hole install and a 0.5 gpm spray that shuts itself off after 55 seconds. Clean design, minimal fuss.
Buy if you:
- Want a touchless faucet in a bathroom or shared restroom
- Hate reaching under the deck for a bulky control box
- Care about cutting water use with a 0.5 gpm spray
- Want a top-mount install you can service from above
Skip if you:
- Need hot and cold mixing at the faucet (this runs a single inlet)
- Fill big pots or buckets and hate the 55-second auto shutoff
- Want a high-flow spray for rinsing dishes fast
| Flow rate | 0.5 gpm / 1.9 Lpm |
|---|---|
| Spout height / reach | 6 in / 5 in |
| Battery | 5-Year CR-P2 lithium (installed) |
| Safety timer | Shuts off after 55 seconds |
| Weight | 3.9 lbs |
| Finish | Polished Chrome, metal |
Wave a Hand, Water Runs
The gooseneck arch is the first thing you notice. It’s a high-arc spout in polished chrome, and it looks like a commercial restroom fixture in the best way. Clean lines, no clutter around the base.
What’s Under the Hood (Or Isn’t)
The headline spec: no control box below deck. That’s the “integrated” in the NextGen Selectronic integrated faucet. Older sensor faucets stash the electronics and battery in a box you have to mount under the sink, then fish around to service. This one keeps everything in the faucet body itself.
The battery is a 5-year CR-P2 lithium, and it ships already installed. The spray is a vandal-resistant 0.5 gpm multi-laminar stream, pressure-compensating so the flow stays steady. American Standard rates that 0.5 gpm as roughly 77% less water than a 2.2 gpm faucet. There’s an Auto Purge that periodically flushes stagnant water, and a Fail-Safe that shuts the faucet off if the power or battery dies. Here are the numbers that matter.
The Demo: It Just Turns On
The sensor response is the whole test, and this one passes cleanly. Hand goes under the gooseneck, water starts, no half-second lag, no waving like you’re hailing a cab. Hand pulls back, water stops. I tried approaching from the side and coming in fast from above; it read both without hesitation. No false triggers sitting idle on the counter either.
The 0.5 gpm spray is exactly what you’d expect from that number. It’s a soft, contained stream aimed at handwashing, not blasting a pot clean. In a bathroom that’s the right call. The multi-laminar pattern keeps it from splashing all over the basin.
And because there’s no handle, the deck stays clean. That single-hole footprint (6.87″ deep, 1.87″ wide at the base) means it takes up almost nothing.
The 55-Second Timer Cuts You Off
The safety timer shuts the water off after 55 seconds, whether you’re done or not. For handwashing that’s a non-issue. But if you’re the type who leaves the faucet running while you fill something or scrub a stubborn dish, this faucet will simply stop on you mid-task and you’ll have to re-trigger the sensor.
The other thing worth flagging: this is a single inlet. It runs cold or tempered water, not a hot-and-cold mix at the faucet itself. If you want warm water, that’s handled upstream at your supply, not by twisting anything on the deck. Neither of these is a defect. They’re just how a low-flow, touchless, single-hole faucet is designed to behave, and they’ll annoy the wrong buyer.
Get it now
American Standard NextGen Selectronic Faucet
Get the best price on Amazon →This post contains affiliate links. I may earn a commission at no extra cost to you.
Who This Faucet Fits
Shared bathrooms are the sweet spot: guest baths, office restrooms, a powder room that sees a lot of traffic. The hygiene case is obvious, no handle means no surface for every visitor to grab, but the no-box design is the less obvious reason to pick this one specifically. Anyone who’s hunted under a vanity for a dead sensor box battery will appreciate never having to do that again.
For a renovation, the math is straightforward: single-hole footprint, no control box, battery already installed, and a flow rate that cuts water use by roughly 77% versus a standard 2.2 gpm faucet. The top-mount install means every serviceable part, battery included, is reachable without opening the cabinet. If you’re tiling in new cabinetry or chasing a LEED point, this is the faucet that doesn’t create new problems to solve.
Touchless vs. a Standard Handle Faucet
A standard two-handle faucet still wins on control. You get precise temperature blending and you can run it as long as you want. The NextGen Selectronic integrated faucet trades that control for hygiene and water savings, and the 55-second cutoff plus single inlet are the price of that trade.
Against other sensor faucets, the big differentiator here is the no-control-box design. Plenty of touchless models make you mount and wire a box under the deck. This one doesn’t, and the 5-year battery lives right in the faucet. That’s less to fail and less to fish for when it does.
Advice Before You Install
Confirm your water setup first. Because this is a single inlet, plan for how you’ll feed it cold or tempered water. If you want warm at the tap, that gets handled at the supply line, so sort that before the faucet arrives.
Check your hole spacing too. It’s a single-hole faucet, but American Standard offers optional deck plates for 4-inch or 8-inch centers if you’re covering existing holes from an old three-hole setup. And since the battery is already installed, you’re basically good to go out of the box for about five years before you think about it again.
Pros
- Touchless sensor turns on and off cleanly, no fumbling
- No control box below deck, everything integrated into the faucet
- 0.5 gpm spray saves roughly 77% of water vs. a 2.2 gpm faucet
- 5-year CR-P2 lithium battery installed and ready
- Top-mount install with top-accessible serviceable parts
Cons
- 55-second safety timer cuts water off mid-task if you’re filling something
- Single inlet, no hot/cold mixing at the faucet
- 0.5 gpm is too low-flow for fast dish rinsing or pot filling
Frequently Asked Questions
How long does the battery last and is it easy to replace?
The CR-P2 lithium battery is rated for 5 years and comes installed. When it eventually dies, the serviceable parts are accessible from the top since the faucet installs from above, so you’re not dismantling the cabinet underneath to swap it.
What happens if the battery dies while I’m using it?
It shuts off. The Fail-Safe design automatically closes the faucet on loss of power or a dead battery, so you won’t end up with water running unchecked. You’ll just need to replace the battery to get it working again.
Can I get warm water out of it?
Only if you feed it tempered water. This is a single-inlet faucet for cold or tempered water, meaning there’s no hot/cold mixing at the faucet itself. Any warming has to happen at the supply line before the water reaches the spout.
Will it fit my sink if I already have three holes?
Yes, with an optional deck plate. The faucet is single-hole, but American Standard sells deck plates for 4-inch or 8-inch centers to cover existing holes from an old widespread or centerset faucet. Grab the plate that matches your spacing.
Is 0.5 gpm enough for a kitchen sink?
Not really. At 0.5 gpm this is tuned for handwashing in a bathroom or restroom, not fast dish rinsing or filling large pots. For a kitchen you’d want a higher-flow faucet.
What’s the Auto Purge feature?
Auto Purge periodically runs the faucet on its own to flush out water that’s been sitting stagnant in the line. It’s mostly useful in restrooms or fixtures that don’t get used every day, keeping the standing water fresher.
Does the finish come in anything besides polished chrome?
This specific model, the 7755105.002, is polished chrome with a gooseneck high-arc spout. If you want a different finish you’d be looking at a different SKU in the NextGen Selectronic line, so check the listing options before ordering.
How hard is the installation?
It’s designed to install from the top through a single hole, which is easier than a lot of under-deck sensor faucets. There’s no control box to mount or wire below the sink, so the main job is the single supply connection and seating the faucet. Comfortable DIYers can usually handle it.
Clicking takes you to Amazon. As an Amazon Associate we earn from qualifying purchases — pricing and availability subject to change.
Get it now
American Standard NextGen Selectronic Faucet
Get the best price on Amazon →This post contains affiliate links. I may earn a commission at no extra cost to you.
About the reviewer
Scott Ayres
Welcome to the Product Demo lab where I (Scott) demo products so you can make an educated buying decision. I keep it real, honest and laid back.
